[ipac] Updating Location changes

[Stuart Miller]

If you changed a description in Horizon, you have to restart JBoss in
order to load that into HIP--HIP retains location descriptions and only
refreshes them on a restart. 

It is maddening that you learn this by trial-and-error and I can't
always remember either because of course this was NEVER documented
anywhere. 

Stuart Miller

-----Original Message-----
From: ipac-bounces at lists.tblc.org [mailto:ipac-bounces at lists.tblc.org]
On Behalf Of Jonathan Rochkind
Sent: Thursday, February 14, 2008 2:59 PM
To: Dynix's Horizon Information Portal,formerly iPac (discussion)
Subject: Re: [ipac] Updating Location changes

When I changed a description, there was definitely something in the HIP 
admin screens I had to find and change. It took me a while to find it. 
Running the mass indexer wasnt' neccesary and wouldn't have helped for 
me.  I just regret that I can't remember exactly what HIP Admin screen 
it was. It took me a couple days of frustration to figure it out, a 
month or two ago.

Cranmer, Donna wrote:
> Michael,
>
>  
>
> I assume you restarted jboss. If that has been done, then you'll have
to
> run mass indexer. We never can remember where we have to force
changes,
> so start with jboss, then run mass indexer. We added some codes &
jboss
> wasn't the answer, so ran mass indexer. Did the trick. I suspect it'll
> be the same for you.
>
>  
>
>                         Donna
>
> Donna Cranmer 
> Technical Services Librarian 
> Siouxland Libraries 
> 201 N Main Ave 
> PO Box 7403 
> Sioux Falls, SD 57117-7403 
> 605-367-8712 
> dcranmer at siouxfalls.org 
>   
>
> ________________________________
>
> From: ipac-bounces at lists.tblc.org [mailto:ipac-bounces at lists.tblc.org]
> On Behalf Of Michael Schulte
> Sent: Thursday, February 14, 2008 2:50 PM
> To: ipac at lists.tblc.org
> Subject: [ipac] Updating Location changes
>
>  
>
> Hello All, I am a bit new to this type of work and have recently come
> across a problem which I am having difficulty resolving.  Hopefully
> someone can offer some advice.  I recently made changes in Horizon to
> the description of a location code.  All the descriptions have been
> correctly changed in Horizon.  However, when I look up resources on
IPAC
> I still see the old location description.  What might the necessary
> steps be to implement these changes to be seen on the catalog?
>
>  
>
> Michael Schulte
>
>  
>
>  
>
>
>   
>
------------------------------------------------------------------------
>
> _______________________________________________
> ipac mailing list
> ipac at lists.tblc.org
> http://lists.tblc.org/mailman/listinfo/ipac
>   

-- 
Jonathan Rochkind
Digital Services Software Engineer
The Sheridan Libraries
Johns Hopkins University
410.516.8886 
rochkind (at) jhu.edu

_______________________________________________
ipac mailing list
ipac at lists.tblc.org
http://lists.tblc.org/mailman/listinfo/ipac